We've designed the HARM Bubbler (High Airflow Recycling Matrix Bubbler) to be a little different. This bubbler provides highly effective vapor conditioning and a recycling function without sacrificing airflow, unlike most recycling bubblers. This makes it suitable for higher airflow setups like ball vapes without adding much restriction on the inhale. The recycling function has been setup to create a whirlpool as water drains back down into the main can of the bubbler. The way a recycling bubbler drains back down doesn't effect the vapor quality, only the speed at which the bubbler can function without flooding up the mouthpiece... and we figure if you're going to do it you might as well make it pretty!
Much like our Chugga-Jug 2.0 we've designed the HARM Bubbler with a thick stable base and supported joint to make it compatible with heavier devices that would destabilize or damage less sturdy bubblers. The Matrix percolator inside allows for lots of airflow while providing a good level of vapor conditioning.
The water level can also be adjusted based on the setup you're using, we tend to fill the central can around half way up for higher airflow setups, though less water can be used to further increase airflow if you have a very free flowing setup like a Screwball. For more restricted vaporizers like most portables you can fill the bubbler a little higher to retain the full recycling function. As with all bubblers more water will add restriction and cool the vapor more so a lot of this is down to personal preference.
Due to the design of the bubbler there's also enough space between the mouthpiece and joint to make for a less scary experience if you're using ball vapes with an unprotected coil (no heat guard)! The HARM-Bubbler can be left on a table and used or easily, safely and comfortably held by hand using various different grips.
Specifications
- High airflow recycling bubbler
- Whirlpool recycling function
- Borosilicate Glass
- Available with 14.4mm or 18.8mm female joint
- Reinforced supported joint
- Thick wide base
- Angled mouthpiece
- Approx. 170mm total width, 95mm wide base and 230mm tall
18.8mm joint version displayed
To clean the bubbler the easiest way is to fill it with ISO, leave it to soak overnight then empty it and rinse through with lots of hot water. A glass stopper can be placed in the female joint if desired to reduce evaporation, this also allows the ISO to be more easily swilled around gently inside to help agitate and remove more stubborn residues. Scrubber Duckys can also be used to assist in cleaning if needed.