Side and base heated XL 3D Ceramic heaters - Compatible with the V5 Micro Diffuser, Core XL, Core 2.0/2.1, TUG 2.0 and CUB devices. These are a solid upgrade from the original 3D ceramic heaters, providing space for larger dabs, more vapor production and less cleaning of your device since the higher walls vaporize more of the material which splashes up when the airflow hits it.
These heaters are available individually or installed in an atomizer housing. They also fit into the Core 2.0/Nice Dreamz RDA housings so if you're running one of them it's just a case of switching the heaters over to the newer XL heater. Since the Core 2.1/2.2 housings are not rebuildable these cannot be installed into them.
If purchasing with a Rebuildable housing, on arrival check that the little screws which hold the wire heater legs in place are done up firmly (not so tight you cut the wire with them!) and that the flathead bolt in the bottom of the RDA is firmly done up (not so tight you damage the ceramic spacer!).
There are also XL Non-rebuildable atomizers which are ideal for convenience since you don't have to change the heater in the rebuildable housings, can just unscrew the old one and screw in the new!
On the Core 2.0 e-rig these will heat a little hotter than the originals at the same heat settings, so stick to blue/green/white settings and start inhaling sooner if you find your material is getting a little toasty. There's no need to do double pre-heat cycles as some people choose to do with the originals heaters.
Variant Compatability
- Heater Only
- V5 XL Concentrate Heater/V5 XL Micro Diffuser
- Core 2.0, XL (rebuildable) or Nice Dreamz Housings
- Atomizer with Rebuildable or Non-rebuildable Housing
- Core XL
- Core 2.1
- Tug 2.0
- CUB
XL Polished SiC Inserts are now available for these atomizers/heaters
Temperature Control Settings (for V5 Micro Diffuser and CUB)
- TCR 220 - 45w - Adjust temperature as desired (vaping temps are usually between 190c-250c)
Heaters are around 0.41 ohms - readings may be slightly higher depending on your box mod as not all box mods read the same due to the way they're set up by manufacturers.
Cleaning
- This is the same as for regular 3D Ceramic heaters, wipe them out after each dab using a q-tip/swab.
- Burn off Cycles can be performed at 37W Max for one to two minutes (requires the Pico Plus with Autofire linked or a DNA-C mod) if needed this can be restarted after allowing the heaters to cool for a couple of seconds in between cycles. To do this hold the setup upside down while performing the burn off cycles. Heaters can be cleaned at higher wattages but may break, we have had success at 45W but 37W is the maximum reliable cleaning wattage.
Includes
- 1 or 2 x XL 3D Ceramic Heater or
- 1 x XL 3D Ceramic Heater installed in Rebuildable housing or
- 1 x XL 3D Ceramic Heater in Non-rebuildable housing
- (Internal heater dimensions approx. 14.6mm width x 12.4mm height)
Please note the last image shows the XL ceramic heater and regular ceramic heater side by side, they have both been installed into the Nice Dreamz housing to provide an easier visual comparison of the two. The XL Ceramic Heater RDA is as shown in the main image for the product.
Don't do hot starts with these heaters, loading cold concentrates into hot ceramic heaters can cause them to crack, always load the dab in from cold!
