Housings for the Ruby Twist Injector Vape. We have made these available due to popular request but would highly recommend, alongside this product, to purchase the Thermal Twist Coil, Bowl and Stand (assuming you already have a compatible PID controller). The Coil will provide an optimal fit for the housing to provide the best experience, it also comes with a handle installed which balances the weight of the housing so that the hot housing stays on the stand. The bowl has been designed to be the correct height for use with this housing so that the airflow works the best... and the stand has been designed to provide a stable setup which does not wick heat away from the housing, allowing for the most consistent experience. It's also wise to grab a Housing Guard to reduce the chance of burns if accidentally touching the Housing.
These can be directly swapped with the Thermal Twist housing if you already have a Thermal Twist kit, it's just a case of switching one with the other and getting the upgraded performance of the Ruby Twist. Everything else in the kit is the same.
Please check out the Rubies Twist Full Kit for full information on this product.
Includes
- Ruby Twist Housing (Grade 2 Titanium Housing)
- Pre-filled with Gemstone Cut Rubies
Housing Switch Instructions (if upgrading from Thermal Twist) - Takes 1-2 minutes
1 - Partially unscrew the bolts on the heat guard using the allen key provided with the original kit, then remove it
2 - Hold the bottom of the Twist housing installed in the coil, unscrew the cap by hand to remove the cap and core together
3 - Holding it upright, unscrew the cap of the twist housing and insert the main part into the coil, then screw the cap back on (be careful not to spill the rubies)
4 - Replace the heat guard and tighten up the bolts!


