Ti-Tc - 24w - 160-260C. Coils resistance around 0.28 ohms.
These are the third largest vapour producing coil for the New Sequoia Atomizer by HVT and our favourite wire based setup for this atomizer. Being quartz the flavour produced is crisp and clean and they are easier to maintain than the porous black ceramic version. Always warm your coil before loading to allow material to melt onto the rods, this increases initial vapour output and reduces the amount of material spat off the coil due to the heat.
We've had the best results using these with the bottom airflow holes fully opened and the top airflow open a crack. Please note new version of this coil are made without bottom airflow holes so they can be used with just top airflow.
Use code "cheaperplz" for 10% off this product when purchased with a New Sequoia Atomizer.
Before first use coils should be placed on Ti-Tc at maximum temperature, then fired for a few seconds to burn off any residues left over from manufacture.
These coils can be loaded multiple times before cleaning as the heavier materials fall off the coil and pool in the bottom. To clean them these coils can be heated and turned upside down to then drain this out into tissue, then heated again and gently blown on to remove anything left on the coil. When the flavour starts to change and the coil cannot be cleaned in this way simply soak in ISO or similar solvent, rinse, dry and fire to clean.